My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crossword Word Search Worksheet
Rate This Puzzle:
Log in or sign up to rate this puzzle.

Semester Exam Review

Name:_______________ Date:____________
Mr. C's Automotive Class
Across
Verbal___ and terminology is important when talking to a customer.
A alternator uses a one way pulley called an ___ pulley.
If there is a fault in a control circuit of the relay it will not ___.
A diode is a one way ____ valve.
Can cause the rubber seals and oring's to swell in a brake system.
If an ohmmeter displays zero, this indicates there is no or little ___.
The brake lining edge codes indicate___.
What grit sandpaper would you use to smooth a rotor?
What type of test can you do to verify the rotor is not warped?
A plastic case is considered to be non ___.
A metering valve that is stuck open will cause the vehicle to__.
The more common resistance of a relay is between 60 and 100 ___.
A defective drive or pinion gear on a starter can cause a ___sound. The teeth of a flywheel that are excessively worn will cause a ___sound. The pinion to flywheel clearance will cause a ___sound.
Known as the more common type of brake fluid___.
The starter drive will not rotate the flywheel because it is___.
Down
Closes the passage to the front brakes until 70 to 300 psi is reached.
A customer concern that state the issue is on and off i known as being ___.
A normal battery ___with the key off is around 20-30 mA.
On a diagonally split brake system the right front is tie to the __.
Brake pedal linkage travels too far.Pedal Linkage may be out of__.
Most manufacturers recommend the brake to be replaced when they are worn to___.
One hydraulic circuit defect can cause the brake pedal to travel too ___.
When you see "OL" this means ___.
To cover the brake linings during a repair you should use___.
Moisture in the air can be ___.
Wheel cylinders do not need depressed when___.
The wires of a commutator are considered to be a type of ___connection.
Grease or other contaminants on the friction surface can cause the brake to ___.
If a diode were shorted in a circuit allowing the electrical flow both directions, it would cause a ___.