My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Answer Key:
Edit a Copy:
Make Your Own:
Crossword Word Search Worksheet
Rate This Puzzle:
Log in or sign up to rate this puzzle.

Subpart P - Hand and Power Tools

Teacher: Ribboy1958
Across
.244 - In the absence of a firm foundation, what must occur to the base of a jack?
.244 - After a load has been raised, the load must be secured by blocking or what other means?
.243 - Adjustment of a grinder guard shall be such that pieces of a broken wheel will be ______ from the operator.
.243(d) - The firing mechanism shall be so designed that the tool cannot fire when what action is taking place?
.243(d) - How many separate and distinct actions are required to fire an explosive actuated tool?
.244 - What type of jack must have antifreeze in it when there are freezing conditions?
.243 - In addition to inspection, what must be done with grinding wheels before installation?
.243(a) - The operating control on hand held power tools shall be located to minimize what kind of operation?
.244 - If a jack is used daily, it would have to be inspected at least every ____ months.
.243 - Blades have to stop doing what within 15 seconds of power shut off?
.243(e) - How many inches is the minimum distance from the tip of the blade to the end of the discharge chute on a push mower?
.243 - All portable _____________ saws having a blade diameter greater than 2 in. shall be equipped with guards above and below the base plate or shoe.
.243 - Hand held power tools may have lock-on controls provided that turnoff can be accomplished by a ____________ motion of the same finger or fingers that turn it on.
Down
.243(b) - A tool retainer on a pneumatic tool prevents the tool from being what?
.243 - A guard on an abrasive wheel grinder must cover the ______, nut and flange projections.
.243 - When a bushing is used with a wheel, it cannot come into contact with what?
.424 - Each employer shall be responsible for the safe condition of tools and equipment used by employees, including tools and equipment which may be furnished by whom?
.243(d) - The firing mechanism must also be designed to prevent firing if the tool is _______ while being loaded.
.243 - The guard on a portable grinder must be located between the operator and the _________.
What "warning" word must be located at the starting controls of every power mower?
.243(d) - Operators and assistants using tools actuated by this means shall be safeguarded by means of eye protection.
.244 - What must be checked on a jack to ensure it can safely lift a load?
.243 - Belt sanding machines shall be provided with guards at each _____ point where the sanding belt runs onto a pulley.
Compressed air shall not be used for ______________ purposes except where reduced to less than 30 p.s.i. and then only with effective chip guarding and personal protective equipment.
.243 - Contact surfaces of wheels must be free of foreign matter and maintained ________.
.243(d) - The tool shall be so designed that it cannot be _____ unless it is equipped with a standard protective shield or guard, or a special shield, guard, fixture, or jig.
.243(d) - The muzzle end of the tool shall have a protective shield or guard mounted perpendicular to and concentric with the barrel, and designed to confine any flying fragments or particles that might otherwise create a hazard at the time of _______.