My Crossword Maker Logo
Powered by BrightSprout
Save Status:
or to save your progress. The page will not refresh.
Controls:
SPACEBAR SWITCHES TYPING DIRECTION
Edit a Copy:
Make Your Own:
Crossword Word Search Worksheet
Rate This Puzzle:
Log in or sign up to rate this puzzle.

Perini 176E Logsaw

Across
Sharpening stones are _______ driven
The local speed of the log saw orbital head should always be ______
_______ stones keep the sharpening stones de-burred for good blade sharpening
A full log profile is when you check the roll _____ of all avail rolls in a log
The log ______ unit is used to provide frictional force to keep log in proper contact to log pusher
Orbital head barrel cam is what allows the Logsaw to have _____ motion
Blade retainer nuts on the orbital head are ________ threaded
The clamps at the infeed and outfeed ______ close and open at the same time as the logs passes through.
The fire eater filter is replaced every ______ shift sooner if needed
If dump timing is off when cutting above 30 CPM adjust speed _______
Sharpening stones are air loaded ______ retracted
To increase the clamp diameter you should adjust the ____ diameter
The Logsaw should be cleaned every _____ hours
Rotational speed of the blade spin unit constantly varied to minimize ________ blade wear
The ______ optics will pause the Logsaw if they are blocked.
This educational tool has been provided by the ______ group.
Down
Frequency and duration of grind can be set by the _____
Vfd stands for variable ______ drive
There are two _________ to detect high temps in the emery system
The blade drive is a ____ ac motor
There are four proxes, one for each lane of pushers, but only lane _____ is responsible for homing
When installing new blade you should set the ______ to 610
To separate trim from cut rolls the Logsaw will either have a shuttle system or a _______ system.
2 sharpening stones, 1 for each side, create the _______ cutting edge
If dump timing is off when cutting below 30 CPM adjust ______ pusher position
The ________ is the master position reference
The blade height prox is meant to protect the ______ from the rotating platform
Orbital support jacking screw and motor are responsible for ________ orbital support structure for blade height/ wear compensation
If the cut length is too long only at high speed _______ the clamp diameter to add drag to the log
The suction unit uses an ac motor and fan to vacuum ______ dust from grinding stone assembly shroud
The cuts that happen between the back of the pusher and front of the next roll
The automatic blade wear offset works by when the prox no longer detects the blade, the rotating platform ________
______ position sensors along with a cam determine direction of travel when returning to home